V 15.0.2: Speed Searchв Control

Ensure your control method (e.g., V/f Control or Open Loop Vector) supports Speed Search, as some high-precision flux vector modes require specific PG feedback tuning to work.

To ensure the drive catches the motor smoothly without tripping an overcurrent fault, adjust the search sensitivity: Speed searchВ Control v 15.0.2

Set b3-01 (Speed Search Selection) to 1 (Enabled) . Ensure your control method (e

Typically set between 100% and 150% of the motor's rated current. This determines how much "effort" the drive uses to find the frequency. This determines how much "effort" the drive uses

Locate the primary activation parameter in your control interface.

Decide if you want it to trigger automatically after a power loss or every time a "Run" command is given. 2. Configure Current and Timing

To prepare or enable the feature in a control system (such as Yaskawa or similar VFD controllers ), follow these general configuration steps: 1. Enable the Speed Search Function